Ad Get The Right Chainsaw For The Job. If your chainsaw stalls instead of producing the reassuringly high-pitched sound of a healthy engine when you press the throttle trigger something is interfering with efficient fuel combustion.
A clogged pickup body fuel filter might still be the problem.
Stihl chainsaw revs then dies. At that stage there is an automatic fast idle going. Chainsaw stalls when giving it gas. A cracked fuel line can cause fuel to leak out and this will prevent it from entering the engine.
Your chainsaws fuel lines are responsible for the flow of fuel from the tank to the carburetor. I am thinking there is a slight leak in the fuel line which shows up under load saw is about 10 years old and the line is very soft Apart from that I am out of ideas. Ad Carbide Tipped Replacement Chains For Your Chainsaw.
A more detailed and intuitive algorithm for removing the carburetor from a chainsaw is presented in the video. If its the carb you will learn how to re. Saw always dies.
I doubt it has more than four or five hours on it. If your chainsaw engine dies at full throttle check the following parts. Our repair guide can help you identify the right part to stop your chainsaws engine from dying at full throttle.
If the saw runs at idle and when you pull the trigger as it seems this is the case it dies unless you let off in time. This video provides information on how to troubleshoot a chainsaw and the most likely defective parts associated with this prob. Ad Carbide Tipped Replacement Chains For Your Chainsaw.
Ad Get The Right Chainsaw For The Job. Turn this Jet Screw out counter-clockwise 18 – 14 of a turn. Usually six hours is not enough time.
It starts and runs fine. Here is how to fix it whether it is a clogged spark arrestor bad fuel filter. Browse Our Electric And Gas Models.
Its easy to do this with Stihl saws. Help please – chainsaw starts fine but dies when given gas. I cleaned the air filter which had become contaminated with dust on the inside of the filter.
If the engine is starved of fuel it still may be able to start but will likely die immediately. I have an interesting problem with a Stihl 026. The weird part is that it will cut fine if I use the top of the bar with upwards pressure from the bottom of the log.
One or two choke pulls can flood it. They are labeled as follows – HHigh Speed Jet LLow Speed Jet and LAIdle Speed. Browse Our Electric And Gas Models.
Put everything back together started the single adjustable jet presuming the Low jet on the WT-403B carb at the 1 turn out from seated. Sometimes you have to give is time to think about the problem. I asked my brother to take a look at it since hes fixed a number of chainsaws and he says it looks like it isnt getting fuel.
It will start up with some work but it idles for a couple seconds then dies most of the time and when it doesnt die on its own it dies when I try to give it any gas. Saw pops with full choke flip up the master control and itll start and rev high for a couple seconds then die. As for the disassembly of the carburetor chainsaw Stihl 180 then everything is simple.
The carburetor fuel lines fuel filter air filter and muffler. Then again you might have flooded the engine when restarting it warm. If your Stihl chainsaw starts up with a reassuring puttering sound but dies when you pull the throttle trigger there likely is an issue with the fuel but the carburetor could need adjustment.
Normal starting routine – prime choke pull about 3 times til it fires a little then push choke off pull a few more times till it starts. Chainsaw starts then stalls. Stihl Chainsaw starts then stalls 01 – Spark Arrestor The spark arrestor is a small screen that prevents the engine from emitting sparks.
Your L screw is too LEAN. Also if you can start and run at idle just fine but it dies when you pull the trigger may just be simple hesitation and idle side of carb needs to be adjusted richer – but if it is like on throttle lock position it starts on choke and you take off choke it then speeds up by itself and dies out without touching throttle thats classic air leak in intake. However as soon as I try to cut wood it chokes and dies.
The chainsaw is pretty new a Poulan 16. 1 bolt is unscrewed on the cover of the fuel pump and 4 bolts on the cover of the main chamber.